"FPR2" Related Products

Human FPR2/Gi/Go Stable Cell Line-CHO

Cat.No.: CSC-RG0469
Cell Line Description: These GPCR stable cell lines are non-force coupled cell lines that are validated for functional cAMP response and are fully characterized for pharmacology & specificity. Each clonal cell line is engineered to express the full length GPCR protein. These GPCR stable cell lines are used with cAMP detection kit for measuring the activation of the target (GPCR).
Background: The FPR1, FPRL1 and FPRL2 receptors belongs to a family of receptors that all respond to N-formyl peptides. N-Formyl peptides are bacterial peptides which induce chemotaxis in neutrophils and other phagocytic cells to sites of bacterial infection.
Growth Properties: Adherent
Morphology: Epithelial-like
Host Cell: CHO-K1
Cell Line Validation: 1. Gene expression: qPCR experiments determined specific silencing of human FPR2.2. Protein expression: FPR2 in this cell line has been validated by immunocytochemical staining.
Application: cAMP assays
Sub-type: N-formylpeptide
Propagation: Complete growth medium: F12 Nutrient Mixure (HAM) + 10% FBS + 1× penicillin + 1× streptomycin + 1× L-glutamine + 800μg/ml geneticin. Atmosphere: air, 95%; carbon dioxide (CO2), 5%. Temperature: 37 °C
Starting Cells From Frozen Cell Stock: 1. Thaw frozen cells very briefly in a 37 °C water bath under sterile conditions until just before ice completely melts (30 seconds to 1 minute). Caution: Longer incubation may result in cell death.2. Remove DMSO from the media by carefully transferring thawed cells to a sterile 15 mL tube, filling tube with complete media without antibiotics pre-warmed to 37 °C, and centrifuge at 300g for 4 minutes to pellet cells.3. Resuspend cell pellet in 5 mL of pre-warmed complete media without antibiotics, transfer to a T25 flask, and grow for 24 hours. Cell recovery is greatly improved when antibiotics are omitted for the first 24 hours.4. After 24 hours, exchange with 5 mL of media containing antibiotics. Antibiotic selection must be applied after the first 24 hours or the expression of GPCR could be lost. 5. Once the cells become >70% confluent in the T25 flask, trypsinize (using a 0.05% trypsin solution) and resuspend with 5 mL of complete media. Transfer the entire cell suspension to a T75 flask containing 5 mL ofcomplete media (containing antibiotics) for continued growth.
Subculturing: 1. Remove and discard culture medium.2. Wash cells with PBS (pH=7.4) to remove all traces of serum that contains trypsin inhibitor.3. Add 2.0 ml of 0.05% (w/v) Trypsin-EDTA (GIBCO, Cat No. 25300) solution to 10 cm dish and observe the cells under an inverted microscope until cell layer is dispersed (usually within 3 to 5 minutes). Note: To avoid clumping, do not agitate the cells by hitting or shaking the dish while waiting for the cells to detach. Cells that are difficult to detach may be placed at 37 °C to facilitate dispersal.4. Add 6.0 to 8.0 ml of complete growth medium and aspirate cells by gently pipetting, centrifuge the cells at 200g for 5min, and discard the medium.5. Resuspend the cells in culture medium and add appropriate aliquots of the cell suspension to new culture vessels.6. Incubate cultures at 37°C.Subcultivation Ratio: 1:3. Medium Renewal: Every 2 to 3 days.
Mycoplasma: Mycoplasma Status: Negative (MycoAlert Kit)
Freeze Medium: Complete growth medium 95%; DMSO, 5%
Storage: Store at -80 °C for less than 2 weeks. Store in vapor phase of liquid nitrogen for >2 weeks.
Preservation: 1. Detach cells from culture dish according to the Sub-Culture Procedure.2. Resuspend cells at a density of 5 x 10^6 cells/mL in freeze medium.Note: A T-75 culture flask typically yields enough cells for preparing two frozen vials.3. Aliquot 1 mL cells into cryogenic vials.4. Place vials in a freezing container and store at –80 °C overnight.5. Transfer vials to liquid nitrogen for long term storage. If properly stored, cells should remain stable for years.
Safety Considerations: The following safety precautions should be observed.1. Use pipette aids to prevent ingestion and keep aerosols down to a minimum.2. No eating, drinking or smoking while handling the stable line.3. Wash hands after handling the stable line and before leaving the lab.4. Decontaminate work surface with disinfectant or 70% ethanol before and after working with stable cells.5. All waste should be considered hazardous.6. Dispose of all liquid waste after each experiment and treat with bleach.
Ship: Dry ice
Gene Name: FPR2 formyl peptide receptor 2 [ Homo sapiens ]
Official Symbol: FPR2
Synonyms: FPR2; formyl peptide receptor 2; formyl peptide receptor like 1 , FPRL1; N-formyl peptide receptor 2; ALXR; FMLP R II; FMLPX; FPR2A; FPRH2; HM63; LXA4R; RFP; FMLP-R-I; LXA4 receptor; FMLP-related receptor I; formyl peptide receptor-like 1; lipoxin A4 receptor (formyl peptide receptor related); FPRH1; FPRL1; FMLP-R-II;
Gene ID: 2358
mRNA Refseq: NM_001005738
Protein Refseq: NP_001005738
MIM: 136538
UniProt ID: P25090
Chromosome Location: 19q13.3-q13.4
Pathway: Class A/1 (Rhodopsin-like receptors), organism-specific biosystem; Formyl peptide receptors bind formyl peptides and many other ligands, organism-specific biosystem; G alpha (i) signalling events, organism-specific biosystem; G alpha (q) signalling events, organism-specific biosystem; GPCR downstream signaling, organism-specific biosystem; GPCR ligand binding, organism-specific biosystem; GPCRs, Class A Rhodopsin-like, organism-specific biosystem;
Function: G-protein coupled receptor activity; N-formyl peptide receptor activity; receptor activity; signal transducer activity;

Online Inquiry

Note: There will be extra charge for optional service!

Please input "biomart" as verification code. Please review Creative BioMart's privacy policy for more information

Optional requirements on this protein    +Expand

Price Inquiry

Welcome! For price inquiries, please feel free to contact us through the form below. We will get back to you as soon as possible.